ISO 14243-1 PDF

Knee wear test ISO /3. Normative References. ISO Implants for surgery – Wear of total knee joint prostheses. Part 1: Loading and displacement. Our equipment allows us to carry out testing with force or displacement controlled kinematics as per ISO (load control) or ISO (displacement. Purchase your copy of BS ISO as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards.

Author: Grogore Moogull
Country: Venezuela
Language: English (Spanish)
Genre: Love
Published (Last): 20 August 2004
Pages: 35
PDF File Size: 8.20 Mb
ePub File Size: 10.61 Mb
ISBN: 630-2-44097-657-8
Downloads: 50578
Price: Free* [*Free Regsitration Required]
Uploader: Zuzahn

CKC received the funding for this grant.

Knee wear test ISO

Standardized Loads Acting in Knee Implants. Effect of anterior-posterior and internal-external motion constraint during knee wear simulation on a posterior stabilised knee design. Nonlinear constraints in AP and TR directions were imposed on the load controlled model. A joint coordinate system for theclinical description of three-dimensional motions: Accept and continue Learn more about the cookies we use and how to change your settings. DOCX Click here for additional data file.

Anterior positioning of kso knee contact points results in a greater AP load Io 9 and higher wear rates.

BS ISO 14243-1:2009

There are two control modes for the wear test during simulated gait: This study found 142243-1 changing the input directions for AP and TR according to ISO —1 and —3 had an influence on the wear rate and wear contours on the tibial insert model. The direction of AP and TR also had a marked influence on the wear contours.


The tibial insert was free to move in the 142431, anterior-posterior, superior-inferior and valgus-varus directions, as well being free to rotate within the tibial component, but was constrained in flexion. Loading and displacement parameters for wear-testing machines with displacement control and corresponding environmental conditions for test, The two models were identical except the load control model had additional nonlinear connector constraints for limiting AP motion and tibial rotation TR according to ISO —1 [ 1214 ].

You may experience issues viewing this site in Internet Explorer 9, 10 or Please refer the support section to see the simulator moving.

Loading and displacement parameters for wear 142431- machines with displacement control and corresponding environmental conditions for test.

The wear of the components is determined gravimetrically, particle analysis can be performed. The success of total knee arthroplasty TKA uso returning knee functionality has contributed to its widening application for treating diseases of the knee that have failed conservative treatments [ 1 ].

Fig 10 shows the wear contours for all models. The rotational axis of the knee and its significance to prosthesis design. A precise and accurate standard for wear performance is crucial for the development of knee prostheses as it predicts the lifetime of the tibial bearing.


Biomechanics of the ido Detailed validation of the wear model. Your basket is empty. Find Similar Items This product falls into the following categories.

Displacement or Force Control Knee Simulators? A study of specimens retrieved post mortem. This is due to the reversed input direction for AP displacement.

Implants for surgery – Wear of total knee joint prostheses Part 2: This may lead to slight differences against data published by the original manufacturer. Author information Article notes Copyright and License information Disclaimer. ios

The impact of variations in input directions according to ISO on wearing of knee prostheses

However, the extent of wear varies depending on the design features of the isi insert and shape of the input curves. The volume of wear was calculated by the difference between the initial volume of the tibial insert and its final volume. Clin Biomech Bristol, Avon. It was calculated for 5 million cycles according to ISO [ 11 — 14 ].

Contact and rubbing of flat surfaces.

The boundary conditions were set according to ISO standards [ 11 — 14 ].